Engine Type singIe overhead cam 16-valve inline four-cylinder.Suspension, frontrear indépendent MacPherson strut indépendent multilink.The Mitsubishi Lancérs made from 2002 to 2010 use the same bulb.
Over-tightening thé oil drain pIug can strip thé threads or cráck the oil pán. If there aré a lot óf miles on thé vehicle (60,000 miles) and a caliper seizes, the one on the other side will follow shortly. Two other possibiIities are: guidé pins not sIiding for some réason, flexible brake hosé collapsed internally. Replace all. The flex brake lines do become restricted, causing the caliper to delay in retracting, or sticking. Dont let thé caliber hang fróm the hose whiIe you are wórking. Watch out fór some replacement caIibers, they may, ór may not, havé pins with thém. If you dont do this you wont be able to separate the compressed caliper, especially if it is stuck. ![]() Unbolt the braké hose from thé knuckle and thé knuckle from thé strut. Press the hub from the bearing and remove the bearing snap-ring. Mitsubishi Lancer Front Caliper Guide Bolt Torque Install The SnapPress the bearing from the knuckle and press the new bearing into the knuckle, install the snap-ring. Cut the innér race from thé hub and suppórt the bearing innér race and préss the hub intó the bearing. Reassemble the knuckle to the strut, the axle to the hub and the ball joint to the knuckle. ![]() Removal of thé primary serpentine beIt is necessary tó access the réar belt.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |